通風管道加工系統布局要減小阻力處理

發布人：http://www.nashramblers.com   發布時間：2023-09-23 10:28:49

通風設備我們都很熟悉，通風管道是連接風機空氣處理設備和進風口的管道，是通風設備的重要組成部分。設計通風管道時，應注意通風管道中的阻力，設應盡可能減小阻力。.設計通風管道時，彎頭應盡可能少，兩個彎頭之間的距離應較大。當兩彎頭之間的距離為管徑的3倍時，阻力增加約80%。

We are all familiar with ventilation equipment, and ventilation ducts are important components that connect the fan air handling equipment and the air inlet. When designing ventilation ducts, attention should be paid to the resistance in the ducts, and the design should minimize the resistance as much as possible When designing ventilation ducts, the number of elbows should be minimized and the distance between the two elbows should be relatively large. When the distance between the two elbows is three times the pipe diameter, the resistance increases by about 80%.

如果是5倍，只會增加30%。自通風管道問世以來，由于其自身的特點和低價席卷了整個市場，受到許多制造商的歡迎。在使用中，要學會該學會維護和清潔通風管道，以便更好地發揮自己的作用。實用：這點應該是重要的一點,也是客戶們所追求的一點,只有達到了工程的效果,這樣客戶才能認可我們的產品。

If it is 5 times, it will only increase by 30%. Since the introduction of ventilation ducts, they have swept the entire market due to their own characteristics and low prices, and have been welcomed by many manufacturers. In use, it is important to learn how to maintain and clean ventilation ducts in order to better play their role. Practical: This should be an important point and also a pursuit of customers. Only by achieving the engineering effect can customers recognize our products.

通風管道加工系統布局要減小阻力。

The layout of the ventilation duct processing system should reduce resistance.

不同含塵氣體性質不同，則凈化的分段處理應不同，當污染源多時可以集中在一個凈化系統中，也可分為幾個系統，但出現污染物混合會引起燃燒爆炸危險不同溫度和濕度的氣體，混合后出現管道內結露粉塵或氣體性質不同，影響回收或凈化效率的。

If the properties of different dusty gases are different, the segmented treatment of purification should be different. When there are multiple sources of pollution, they can be concentrated in one purification system or divided into several systems. However, mixing pollutants can cause combustion and explosion hazards. Gases with different temperatures and humidity may result in condensation of dust or gas properties in the pipeline after mixing, which affects recovery or purification efficiency.

管道加工系統布局中要保證整體系統的漏損小，確保吸塵口的有足夠的風量。

In the layout of the pipeline processing system, it is necessary to ensure that the overall system has minimal leakage and sufficient air volume at the vacuum cleaner.